 |
The DB8 TV Antenna comes with:
- 2 reflectors
- 2 sets of bow tie elements
- 4 sets of bolts with aluminum sleeves
- 2 cross braces
- combiner bars with 75 ohm transformer
- 2 mast clamps
|
 |
1. Attach combining bars to the binding posts
on the antenna (bow tie) elements. Tighten
using supplied wing nuts. This electrical joins both halves of the antenna. |
 |
2. Left, both sets of elements joined with the combiner bars. The transformer is in the center. |
 |
4. Next, attach the cross braces to the rear of the reflector as shown using supplied bolts.
|
 |
5. Note: adjustable U bolt mast clamps face the rear
|
 |
6. Attach the reflectors to the elements using the supplied bolts and spacers. Slide the spacers over the bolts so the front and back halves are separated by 3.
|
 |
7. Assembly Complete.
The DB8 assembled and mounted on optional J mount mast with pa-18 pre amp (not included)
|
Helpful Tips:
- If your cable run is greater than 75’, A UHF pre-amplifier is may be required.
- UHF signals are line of sight. Get as much elevation on the antenna as practically possible.
- Attic Installations will cut 40% -50% of your signal strength cal.
- KEEP ANTENNA AWAY FROM POWER LINES
|
1999-2009 Solid Signal,
Signal Group LLC & Affiliates 