Gain of 15db VHF/UHF and a 1.8 dB maximum noise figure
Frequency range 40-862 MHz
Antenna Amplifier Installation
The PA-18 is a powerful low noise signal amplifier. It will perform best when connected properly. Remember an amplifier cannot create a signal. It will help over come the loss caused from cable runs and splitters.
The PA 18 comes with:
Low noise pre amplifier
Low loss power inserter
12V DV power supply
2 foot coax cable
4 foot coax cable
A pre amp will work best when it is amplifying the signal at its strongest point; nearest the antenna.
1. Connect the antennas transformer to the pre amp "In" port as shown using the supplied 2 foot cable.
2. Strap the pre amp to the antenna mast using the supplied cable tie.
3. Run your coaxial cable down lead (not supplied) inside your building and connect to the right port of the power inserter. (Do not reverse the connection!!)
4. Connect the left port of the power inserter to your digital receiver using the supplied 4 foot cable (above). (Do not reverse the connection!)
5. Plug the inserter to an 110v power source.
Here are available downloads related to this product:
Product Reviews for Antennas Direct Ultra Low Noise VHF UHF TV Antenna Pre-Amp(PA18)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!
Average Review (2 reviews):
Recent Review: poncho167 - Fox Lake, IL - 5/29/2014 Worked great
Worked great poncho167 - Fox Lake, IL - 5/29/2014 6:15:12 PM The PA-18 antenna amplifier really brought my signal to life. I installed a whole house antenna system and it tested fine going to one TV only missing one channel. When I hooked up the other TV's using a splitter, now some channels were struggling or not appearing at all especially when there was over-cast weather. Now I can see all the channels without any issues but an occasional flicker on a hard to reach channel, but it seems to correct itself on that.
Well worth the money in my situation. I also received great customer support!
performs as expected j - CT, CT - 9/11/2012 delivers performance as advertised. took very poor stations and brought them to a watchable level. this preamp is being used with an xg91 antenna(which also performs admirably). the big plus(and reason i chose the amp) is that it is powered by 12volts dc and by eliminating the 12volt transformer and feeding 12volts directly to the unit i am able to use it in my camp trailer that is without any 1
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).