Cut the cord with ease! The ROTR100 makes it easy to add a rotator to any antenna by eliminating the need for a separate cable run for the rotator control. Perfect for those who live between two major cities or anyone who needs to move the antenna for the best reception.
ELIMINATES THE NEED FOR ROTATOR WIRE
99 programmable memory locations, which can be assigned the same number as the channel being received
This unit is compatible with any mast or pole between 1.25’ and 2’ inchs in outer diameter
One cable carries off-air signals, rotator power, control and pre-amp power
The Hall sensors count every motor revolution resulting in 2 degree accuracy
120 inch lbs. of mechanical torque
18VDC at up to 80 ma. When pre-amp is not used, this is automatically sensed and the pre-amp power is switched off.
Display and Control: The indoor controller features a 000 degree to 450 degree digital compass delay
Handheld IR Remote: Software codes available on most higher end universal remote controls
Will NOT work with antennas that exceed 131 inches, so the CM3671 and HD8200U are not compatible
Direct access to a location
Eliminate the need for multiple cable runs with this revolutionary antenna rotator which uses the same coaxial cable that you run to your television to control the rotator.
New Spin on an Old Technology
Introducing the new Eagle Aspen single cable off air antenna rotator; model ROTR100. The days of having to run separate "3 conductor rotor wire" between the drive unit and the control unit are in the past. Pro Brand has developed the ROTR100 utilizing DiSEqC code that sends commands to control the drive unit along the same coaxial cable that brings the television signals from the off air antenna into the house. Optional pre-amplifier power can also be supplied via this same cable. Whether performing a new install or retrofitting an existing antenna system, the ROTR100 provides for a fast and easy installation. Additional features have been added making the entire system installer and user friendly.
Rotation Time 60 second (max) for 360 deg Motor Current 350 mA (max) Mechanical Torque 120 inch-lbs Return Accuracy 2 deg Position Sensor Hall sensor Signaling Format DiSEqC 1.2 Pre-amplifier Power +17VDC at 50mA (max) Input Power 120VAC,20W Attenuation -Control Unit 1 dB (max) 54-806M Hz Attenuation -Drive Unit 1 dB (max) 54-806MH Suggested Coax Length: 200 (max) RG-6 solid Copper center conductor with no pre-amp 150 (max) as above, but with an 80nA pre-amplifier 75 (max) RG-6 copper coated steel with no pre-amp
Here are available downloads related to this product:
Product Reviews for Eagle Aspen ROTR100 One-Cable Antenna Rotator (ROTR100)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!
Average Review (21 reviews):
Recent Review: BarrieB - Near Boston MA, Near Boston MA - 3/28/2013 Excellent Product
Excellent Product BarrieB - Near Boston MA, Near Boston MA - 3/28/2013 This rotor is the only one I found that has direct feedback from the rotor to the indicator unit to keepthe indicator in sync without frequent resynchronization.I use an amplifier on the antenna so did not want to feed power through the RF cable.This rotor works FINEwith a separate two wire rotor power feed if you just cut a coax cable and solder it to the wires on each end so the connect
Love my Eagle Aspen hoochie39 - lockport, rt ny - 3/28/2013 i needed a roto-antennae to bring in FM stereo for my tuner and Eagle Aspen got my pick!VERY easy to install and NO PROBLEMS!! HIGHLY RECOMMENDED!
BEST PRODUCT FOR THE MONEY THUNDER - NW ARKANSAS, NW ARKANSAS - 3/28/2013 TERMINALS WILL SNAP OFF UNDER BASE IF OVERTIGHTEND.IT IS GOOD THAT I KNOW HOW TO REMOVE BASE PLATETO SOLIDER THE TERMINAL ENDS BACK TO THE ORIGINAL POSITION AND THE ANTENNA ROTOR WORKS GREAT. I WOULD CONSIDER REPLACING YOUR BROKEN ONES IF YOU HAVE ANY THAT NEED THIS REPAIR JUST DROP ME AN EMAIL AND I WILL CONSIDER HELPING YOU OUT.
Works Great BIG WES - Wisconsin, Wisconsin - 3/28/2013 It lets you know in what direction your antenna is pointing at all times with its degrees readings and the preprograming works great
fantastic product super deal Nanjemoy Bill - Nanjemoy, oyMary - 3/28/2013 Good for general antenna pointing. Very nice digital readout.
best roter around mick the antenn - union grove wi., union grove wi. - 3/28/2013 had 1for 7 mounths stop working sent it in for repair sent me a new one.
AWESOME! HDforfree - Menard county, enard county - 3/28/2013 This one wire setup is the best system for a home owner to install. Are able to get stations over 70+ miles away with 100% signal. I do not see the signal loss thru the rotor as stated on another review. If you want HD for free but this and the DB4E antenna and you will not be disappointed.
Reliable rotor Happy Camper - Sublette IL, Sublette IL - 3/28/2013 Easy to install.Like the one cable for power and signal.It also supports my antenna amplifier.Four months and no problems.I use at summer place so no experience in the winter.
Eagle Aspen ROTR100 Top Performer 1ADAM12 - Simi Valley, i Valley Ca - 3/28/2013 Powers and moves my 7 foot UHF Parabolic dish with ease. Dead on accuracy.
Its GREAT UP ON A ROCK - Rosamond CA., Rosamond CA. - 3/28/2013 I live in a dead zone in CA.this Rotor with a C-4 AntennaI can lock in a signal. Very EASY toINSTALL! And I DONT have to pay for TV.
QUALITY THE ONLY ONE TO BUY..AAA+++ JUNIOR - SHELBY MICHIGAN, SHELBY MICHIGAN - 3/28/2013 the best for my beams 6 footaccurate.. reliable this is the one to buy[...]...AAA+++
Easy to install JR - Lancaster, ster SC - 3/28/2013 Product was easy to install - rotates the antenna as it should - no problems with the unit.
ROTR100: I would buy this product again! TeoNeX - Holland-Europe, Holland-Europe - 6/6/2012 Very accurate (1-2 degr. DISEqC!) pinpointing antenna-system also under windy/rainy weather-conditions. (* Use is in Europe-Holland).Hope to make soon a complete film impression on You Tube; the best reference I think. In accuracy far the best...the CM-versions may be a bit stronger..when using extreme long antennas.I can and will recommend this unit to ALL beginning (low starting-budgets) HAM
Works great! Mick D. - Millersburg, lersburg IA - 9/24/2011 One cable hookup it doesnt get much easier than that. I am very happy with the ease of this antenna rotator.Simple to install and operate.
Excellent! The Fudd - Southwest Michi, Southwest Michi - 5/28/2011 Purchased this because it able to to its job without having to run a separate power supply to turn the rotator.Works great.Have had this up for about a week now and seems to be holding up to the weather (has been raining for nearly every day the past week and have had windy conditions too.)I would recommend it to anyone who has a need for this type of product!
Works with one cableprice is good Tommy T - Banner Elk N.C., Banner Elk N.C. - 12/18/2010 Easy to install works good with one cable amp. and all.Dont know how reliable it is only usedit for one week.
Best Rotor I Ever Owned BusaD - Cumberland, erland VA - 9/27/2010 Just make sure you use a single power thru splitter if you are plaining to use a power amplifier. I am using a DB8 antenna getting excellent reception from 70 miles away. I have 4 tvs on my set-up. I went through a little problem until I found this out. The single coax cable feed works great. Make sure you use the recommended power amp. Broadcast station memory is awesome. You will love this thi
Working as advertised Dave - Gahanna, OH - 3/28/2013 Been using this rotor for several weeks now for OTA TV without any major issues.I have it mounted inside on the second story - using an IR remote extender to control it from the first floor living room.I have seen better signals all around when compared to my prior rotor/amp combo.Its also nice to know which direction it is turning - as well as being able to specify the degrees directly (ne
Glad to see this product back Kitty - Dover, - 3/28/2013 Had this rotator for 3 weeks. Especially like the fact that I can see which way it rotates and being able to set the channels that I watch with the remote.
Has Slight Lateral Play In Bearings JCEnterprises - USA, USA - 3/28/2013 Pretty decent for the money. Hard to find anything in this price range that would be better. I just ran a piece of coax from the rotator to the controller instead of running my signal wire through it. Ive even mounted a security camera above the rotator so I can pan all around my house 360 degrees. Works like a champ so far! A support bearing a couple feet up on the pole above the rotator would b
signal loss occurs when using 1 wire. gcrisler - Rice Lake, Lake Wisc - 12/8/2011 We live in a deep fringe area. 70 miles to the transmitters in Minneapolis with a large hill/bluff about 2 miles away. Stations are difficult to pick up without suffering dropouts. I have tested this rotor and have determined that there is significant signal loss when the signal passes through the rotor as it does with the one wire setup. If you are in a deep fringe area use the 2 wire option to
Get the Eagle Aspen DTV2BUHF and see how to get
free TV channels. Ditching cable? This antenna lets you get all the popular shows. Cut the cord from cable for good. Your favorite local news, sports and weather are ...
Eagle Aspen 8-Way Splitter Cable TV Antenna(P-1000-8AP-GX)
These dependable splitters are designed to work in 5-1000MHz range
and feature zinc die-casting and machined F-ports. The mounting tabs come with screws and grounding ports. Features. 5-1000 MHz. All ports power passing.
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).