Dimensions: 3 7/8 x 7 3/4
Multiswitch is passive, powered only by the connected satellite receivers.
Wideband frequency multiswitch: 250-750 Mhz, 950-1450 Mhz, 1650-2150 Mhz
To be used with AT9 or AU9-S Ka/Ku DIRECTV satellite dishes
No external power required - power to operate switch is dervived from the receiver
Do not put any terminator on any unused input/output ports of this switch
Works with all DirecTV receivers and dishes
Flex Port 1 and 2 are for the international dish only, they will not pass off-air or cable tv signals
6x8 multiswitch designed to interface with 99°/101°/103°/110°/119° DIRECTV satellites. To be used with DIRECTV AT9 Ka/Ku satellite dish for MPEG-4 compression HD compatible receivers.
|• DIRECTV Dual LNB
• DIRECTV Triple LNB
• International 95 W and 72.5W (when combined with any of the other dishes mentioned)
DIRECTV Receiver Compatibility
|This multiswitch is compatible with ALL DIRECTV receivers
|Frequently Asked Questions
|Q. Will this work with my OTA TV Antenna?
A. No, there arent any inputs for TV antenna because this is a wide band multiswitch.
Q. Can I use this to add an International Satellite Dish to my system?
A. Yes, in fact its one of the only Multiswitches you can use to combine international satellites 95W and 72.5W with a DIRECTV Dish.
Q. Ive got a DVR that takes two lines, can I just run one of my lines into this and split it both tuners?
A. No, you must run all four satellite signals into this switch to get eight outputs.
Q. Does this unit require power?
A. No, this switch doesnt require a power supply. It actually draws voltage from the receivers.
This is the proper multiswitch to use for an installation that does not need whole-home service. It provides up to 8 tuner support and will handle signals from all five DIRECTV satellite locations (99, 101, 103, 110, 119) as well as MPEG-2 and MPEG-4 signals and Ka/Ku band signals. Installations for whole-home service should use the SWM-8.