Measure cable resistance, in-line current, voltage, 22 kHz tone and DiSEqC essages
Easy to read display and keypad
Tune to ANY DIRECTV transponder - National and local spot beams
Powers ALL LNBS including SL3 SWM and SL5 SWM
USB port for transferring data to a flash drive and for updating firmware
EIV can be used to troubleshoot and pinpoint problems anywhere within a distribution network
Several additional features can be used to quickly identify faulty equipment in an installation
Test individual cable runs, tuning to any DIRECTV Satellite transponder, testing communications between SWiM and IRD, measuring in-line voltage, current and tone, and performing a complete transponder survey
Carrying case, 100 to 240 VAC Power Adapter, 12 VAC vehicle power adapter, battery pack, F-connector, 25 cable test load, 512 MB USB flash drive (contains User Manual)
Newest Version of AIM Meter! We Are an Authorized DIRECTV AIM Meter Dealer
To download the latest AIM Firmware Click Here. To download the latest Database Click Here
AIM signal meters will only be shipped to the customers billing address used when placing the order. We will not ship to third party location.
On-screen instructions guide technician through installation, EIV and troubleshooting
Efficient, Rugged, and Versatile
The AIM Was developed by DIRECTV, Trilithic and Indesign to provide customized features for installing and troubleshooting DIRECTV Satellite receiver systems. The AIM is a rugged meter suitable for both indoor and outdoor use. A fully charged AIM can be use for all aspects of installation and troubleshooting as many as six single-family homes.
The AIMs large display and keypad make it easy to navigate to the many features of the meter. On-screen directions guide the technician through ODU installation, extended installation verification, and other troubleshooting tests. A USB port is providedto transfer data from the AIM to a flash drive, and for upgrading the AIM firmware.
Extended Installation Verification (EIV)
EIV can be performed right after ODU alignment whiel the technician is on the roof to uickly confirm that pointing is satisfactory. This gives the installer confidence that IRDs isntalledi n the home will pass IV. EIV can also be used as troubleshooting tool to pinpoint problems anywhere within a distribution network.
Several additiona troubleshooting features can be used to quickly identify fault equipment in an installation. the AIM Allows testing of individual cable runs in the distribution network, tuning to any DIRECTV satellite transponder, testing communications between the SWiM and the IRD, measuring in-line voltage, curretn and tone, and performing a complete transponder survey.
|Frequency Range||250-2150 MHz|
|Signal Level Range ||-10 to -69 dBm|
|RF Input Connector||Replaceable F Connector (2)|
|Input Inpedence||75 OHM|
|LNB Power Supply||13 Volts/ 18 Volts|
|SWiM LNB Power Supply||21 Volts|
|Communications||USB flash drive|
|Battery||8 - cel, 9.6 Volts, 3.8 AH rechargeable NiMH|
|Operating Temperature||-20° to + 125°F (-28.9° to + 51.7° C)|
|Storage Temperature||-40° to + 150° F (4.4° to 37.8° C)|
|Battery Charging Temp.||40° to 100° F (4.4° to 37.8° C)|
|Display||240 x 160 pixel, transflective backlit LCD|
|Weight ||2.54 lbs. (1150 g)|
|Dimensions ||244 x 118 x 59 mm |
9.6 x 4.6 x 2.3 in.