Gain: VHF 17dB, UHF 19dB
Input: 82 CH 75 Ohm
Output: 75 Ohm
Gain: VHF 17dB / UHF 19 dB
Noise: VHF 2.8 dB / UHF 2.8 dB
Made of high impact ABS material, mast mounted for easy installation.
Max Total Input µV VHF: 110,000
Max Total Input µV UHF: 93,000
Includes: Pre-amp, PS-1403 power supply, power injector and 6 foot coax cable
Mast clamp will accommodate up to a 1 ½” mast.
You can use the 1296F
as a variable attenuator to control the Db Gain
Learn How to install a pre-amp by clicking here
Compare with other pre-amps by clicking here
Output: Single 75 Ohm
Variable and switchable FM trap.
Maximum Total Input for VHF 110,000 V UHF 93,000 V
Used to overcome any losses in coax cable from the antenna to your TV.
This mast mounted pre-amp takes one 75 Ohm input and has a gain of 17 dB VHF and 19 dB UHF. Features a selectable FM Trap. An efficient way to make up for the loss from long cable lengths and splitters. This amplifer also helps to make up for line loss and insertion loss.
Chromstar 2000 Series Antenna Pre-Amplifiers
Features 75 ohm input for convenience and easier installation. Universal housing can be used with any off-air TV antenna. Made of high impact ABS material, mast mounted for easy installation. Flexible polyethylene boot covers on 75 ohm. Zinc-plated steel hardware; all mounting hardware included.
Selectable FM trap reduces FM signals (88-108 MHz) -15 dB to prevent overload, tunable FM trap reduces a 3 MHz band width by -12 dB. Both adjustable — switchable without opening the housing.
Transistor burn-out virtually eliminated with specialized circuitry featuring fast recovery diode that protects against lightning-caused pulses. Operating temperatures -40° to +140° F. 117 VAC UL and CSA approved power supply is included. (Does not include F-connectors.)
NOTE: Preamplifiers and/or amplifiers only amplify the signal your antenna receives. They cannot extend the receiving range of an antenna or help pull in signal. Also, DO NOT use the higher gain models within 35 miles of your transmitters.
U.S. Patent No. D335,887, D358,365, 5,515,240 (Power supply housing design)
Wiring Diagram can be seen below ;
This item has been Discontinued, the replacement model is the LNA-200 If your antenna line will run for a long distance or be split several times, a pre-amplifier is a great way to make sure that you get a solid signal at the television. The Winegard AP8700 Chromstar 2000 adds 17dB (VHF) and 19dB (UHF) to a 75 ohm signal.