Easily locate your satellite signal. Connects to your digital satellite line to easily calibrate the optimum signal. SF-95 is a satellite finder that helps to make precise dish set-up easily. Its ultimate sensitivity will indicate 0.2 dB level difference in 950 to 2050MHz.
Pocket satellite finder
Highly sensitive illuminated meter
Built-in miniature lamp & buzzer
75Ω, 950MHz–2,250MHz input
-40dBm–10dBm input level
13V–18V DC power requirements
SF-95 is miniature (3.03" x 2.36" x 1.10") and light weight (95 gm).
Now with H/V and 22KHz indicators.
SF-95: Iindicator lights for verifiying that your receiver is set to
Horizontal or Vertical polarity and if 22KHz tone is on or off.
Green H/V light indicates Vertical Polarity.
Red H/V light indicates Horizontal Polarity.
Red 22KHz light indicates 22KHz is ON.
When aligning a C-band dish do not use your meter in front of the dish
to avoid full scale readings.
When connecting to a LNBF with gain higher than 65dB, insert a 5dB
attenuator between the meter and the LNBF. If a attenuator is not
available you may use a long coax (60 feet or more) between the meter
and the LNBF.
If the meter needle is jumping the sensitivity is too high. Adjust the
S.A. level on the back of the meter by punching through the label where
marked. Be very careful not to damage the adjustment by turning it too
far or too hard.
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).