Availability: Usually Ships Same Day Condition:New
Your Price: $11097
List Price: $499.95
Single-Wire Multiswitch technology allows DIRECTV receivers and DVRs to connect using a single wire. One wire can be split to add a second receiver line without going back to the multiswitch. Convert an older dish to SWiM technology without re-aiming. This multiswitch allows for 8 tuners. DIRECTV DVRs use 2 tuners each. HR34 DVR uses 5 tuners. Contains a 29volt power inserter for use with SWM-8 or SWM-16 adapters. It can be run from the power passing port of a splitter or, on the SWM-16 can be run from the separate PWR port. Terminate all unused connections. Also included is the correct splitter to use for DIRECTV whole-home service. Use only "green label" splitters. This splitter also has one power passing port labeled in red.
Provides eight independent channels for supporting up to 8 DIRECTV satellite tuners
Supports six (6) LNB inputs, each triple-band stacked four ports (Ports 1 - 4) cover existing 99°/101°, 103°/110°/119° satellites, plus two Flex Ports (95º sat and 72.5º sat)
Compatible with the D12, R16, R22 all H and HR series receivers
Click the specifications tab to watch a video about the SWM-8 Multi-Switch.
29V Power Inserter included - runs off AC power
Grounding port provided
Green-label 4-port splitter for use with all current DIRECTV receivers
The Winegard SWM-840 SWM-8 Switch Kit allows the use of DIRECTV SWM-only technology receivers with non-SWM Winegard mobile satellite TV antennas. The SWM-840 Kit includes: SWM-8 switch, power inserter, 4-way splitter, and mounting hardware. Note that Model SK-SWM3 SWM TRAV'LER antenna (Coast 80828) operates with DIRECTV SWM technology without separate accessories.
The new SWM-8 allows installers to run an AT9 or AU9 DirecTV satellite antenna plus 2 Flex ports (72.5 & 95) down a single RG6 Coaxial cable! At the end of the single wire a SWS-2, SWS-4, or SWS-8 splitter is required (not included) to distribute the signal to as many as 4 DVRs or 8 HD receivers! Please Note the SWS series of splitters are specially designed for the SWM-8; you must have an SWS-2, SWS-4, or SWS-8.
The SWM Port Single Wire Solution is ONLY compatible with the H20, HR20 (Firmware .2042), H21, and HR21.
The three "Legacy" ports are compatible with all older Receivers, however, each single tuner receiver using the "Legacy" port requires a cable running directly to the SWM-8 unit. DVRs using the "Legacy" ports require 2 cables coming back to the SWM-8 unit. Features:
Provides eight (8) independent channels for supporting up to 8 DIRECTV satellite tuners
Provides two outputs to serve two customer dwellings (typical)
Contains a built-in diplexer for combining off-air signals with DIRECTV satellite signals onto a single home-run wire to the dwelling
Provides AGC for the satellite input signal.
Die-cast housing is suitable for both indoor and outdoor use.
Supports six (6) LNB inputs, each triple-band stacked four ports (Ports 1 - 4) cover existing 99/101, 103/110/119 satellites, plus two Flex Ports (95 sat and 72.5 sat)
Uses only 1 RG6 between SWM-8 and STS Splitter (not included)
Maximum Distance from SWM8 to Splitter: 200
SWM Port Compatible With:
HR21 HD DVR Receivers
H21 HD Receiver
HR20 w/ .2042 Firmware Update
H20 w/ .2042 Firmware Update
Satellite Input Frequency Range: 250 - 2150Mhz
Terrestrial & SMATV Input Frequency Range: 54 - 806Mhz
Return Path Input Frequency Range: 5 - 40 (CMTS return path must use 33-40 MHz band)
Number of Input Ports: 6 Satellite & 1 Terrestrial /SMATV
Supports both DIRECTV and Dish Network. Features. IF polarity selection
is controlled by remote voltage and 22 kHz provided by the receiver Return path compatible Must be used with System Launch Amplifier SBK 5502 NF. Return path compatible. High ...
Works with phase III DIRECTV dishes that receive 101, 110
and 119.. Features. Integrated energy-saving switching power supply ( 100 … 240 V / 50 … 60Hz ). This multiswitch supports a standby mode. The SAT-IF amplifiers and the ...
Spaun SUR 420 F DiSEqC Relais. Features. 4 satellite for
1 participant. DC outlet: max. 500mA. Remote supply current: 30mA. Dimensions: 140mm x 82mm x 38mm. 3 adjustable modes. Universal interconnection. DiSEqC Multiswitch SPAUN SUR 420 F to the ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).