This part allows the use of separate UHF and VHF antennas for better reception. It can separate the VHF frequencies from the UHF ones or combine the input from two antennas into one. This is only suitable for over-the-air use, not for satellite use.
Filters and mixes VHF and UHF signals allowing mixing of multiple antenna onto single cable
May be substituted for another manufacturers VHF/UHF or lo/hi combiner
Note: Units Vhf side DOES NOT pass UHF signals. Uhf side DOES NOT pass VHF signals.
Manufacturers may vary depending on availability
ONLY 0.5dB max insertion loss
Reduces harmonics and out of band interference for improved amplifier performance
Min Rejection 23dB/VHF
Impedance 75 Ohms
Machined F-Connector Threads
Epoxy Sealed Back Cover
VHF-Band DC Power Passive for remote preamplifier powering
Yellow-Chromate Plated Zinc Diecast Housing
Separates and isolates VHF (54-216 MHz) from UHF high (470-809 MHz) signals providing for clean insertion into headend strip amplifier. Filters and mixes VHF and UHF signals allowing mixing of multiple antenna onto single cable.
Product Reviews for Pico Digital UHF VHF Band Separator/Combiner for Antenna (UVSJ)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!
Average Review (8 reviews):
Recent Review: Jim - Raleigh, NC - 10/16/2015 BE careful
BE careful Jim - Raleigh, NC - 10/16/2015 10:19:25 AM The High/Low substitute .Low side Will pass VHF high band. High side WILL pass UHF. I have tried this on 3 configurations all gave great quality!!
well made Pete - Redondo BeachC, Redondo BeachC - 3/28/2013 I had one antenna tuned to ch8 VHF which was very weak signal. The second antenna was for UHF.It did the job.
Worked for my application BR - Middletown, letown IN - 3/28/2013 Used to combine a large boom vhf antenna with a Clearstream 4 uhf antenna. Im able to pull in problematic channel 8 with the vhf antenna and most other uhf channels with the Clearstream 4. Tried a $13.00 [@] combiner with no success. This is a good product.
This product works! eaglemax45 - Fairview, ew NC - 3/28/2013 I am using two of these devices to deliver clean digital TV signals to a preamplifier on a roof installation for home distribution. I installed them in order to configure four stacked antennas (UHF and high VHF) aiming in different directions and can now receive 8 carrier signals (18 channels) off-air. No more cable/satellite/subscription fees! Signals are received from Asheville NC; Charlotte N
Works for FM JB - Charlottesville, Charlottesville - 6/28/2011 Have no VHF stations but used it to split off FM to the stereo and UHF to the TV from a roof top antenna.
Does the job! Jeff - Shoreline, line WA - 11/15/2010 We have a ChannelMaster 4221 which does a great job except on VHF ? our channel 9 reception was spotty even though there?s plenty of signal strength here.I built a simple folded dipole (with balun) for channel 9 and used the UVSJ to combine the outputs of the CM4221 and the dipole. Problem solved!
BE careful before you order!!! Jr - Benson, NC - 3/28/2015 9:41:14 AM I was looking for a separate UHF/ VHF inputs instead they sent me a Blonder Tongue HI/LO device. If you get one of these connect the UHF side to the HI input & Vhf to the LO input. then add to a pre-amp. IF you use a UHF/VHF antenna & combine it with a separate Vhf antenna. connect the U/V antenna to HI side & HI Vhf side to LO side
works Tuner - Murrieta, ta CA - 3/28/2013 It works!
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).