Vericom offers this 2-way, power passing splitter with high performance circuitry board and sealed back cover. This splitter has DC power passing to all ports for remote LNB powering applications and powering antenna pre-amplifiers from the headend.
Distribute your RF signal to two locations
75-ohm impedance for both outputs provides the best possible signal
TRIPP LITE P516-001 Monitor Y-Splitter 1ft (P516-001)
Tripp Lites 1-ft. VGA/XVGA Monitor "Y" Splitter cable provides an
inexpensive alternative for splitting the video signal from your PCs VGA port to two monitors (up to 800 x 600) that use standard 15-pin plugs. Perfect for laptops to ...
Cabletronix 8-Way Splitter All Legs Power Pass (CTLBD-8P)
8-way high frequency splitter, all port DC passive and diode
protected, commercial grade model. Can be used as a splitter or combiner. Full bandwidth 5 MHz to 2300 MHz. DC passing, Internal circuit board, Shielded housing. High performance, maximum ...
TERRAWAVE 800-2500 MHz 2-Way Outdoor Splitter with N Jack (F
Center Pin). Provide RF coverage in separate areas with a single access point or bridge, compact, lightweight design, easy to mount, high isolation, low insertion loss and minimal VSWR.. ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).