The Spotwave 100-10005-13 cable assembly is for use with the Spotwave 2500Xe adaptive repeater. This coax cable assembly is pre-assembled in a 50 meter (164 feet) length with F male connectors attached. Cable assembly is made with low loss RG11 coax cable. If you have a Spotwave 2500Xe adaptive repeater than you need a Spotwave cable assembly.
WARNING. This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have an FCC LICENSE or express consent of an FCC Licensee to operate this device. Unauthorized use may result in significant forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
MMCX connectors are snap-on interface RF connectors that provide frequency
performance up to 6 GHz in one-third less the size of SMB connectors. Ideally suited for the antenna, communication base station, and other applications in which small size and ...
BELDEN 1673A RG-402/U type "Conforable" coax cable. 50 ohm. Alternative
to semi-rigid and flexible coax for "black-box" applications.. Features. Manufacturer Warranty: 10 years. Special Order Product. Non-Cancellable and Non-Returnable..
Consolidated Wire 500' of RG316/U MIL-C-17 TFE White
This is a silver-plated copper covered steel RG-316/U cable from
consolidated wire. It features a center conductor diameter of .060 inches, a nominal core O.D. of 0.060 inches and silver coated copper wire braid 95% coverage.. Key Features:. Center ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).