Availability: Usually Ships Same Day Condition:New
Your Price: $38099
List Price: $475.00
Distribute up to four HDMI audio/video source signals to any of two locations using this HDBaseTT 4x2 HDMI Matrix Switch from Tech Choice! This 4x2 Matrix Switch features four HDMI video inputs and two outputs. One of the outputs is a standard HDMI port for a local connection while the other is an HDBaseT RJ45 jack for an extended connection. The HDBaseT technology allows for a full bandwidth 10.2Gbps data throughput to distances up to 328 feet over a single Cat5e or Cat6 cable.
4x2 HDMI Matrix with 4x HDMI inputs and 2x HDMI outputs
Full Matrix can simultaneously distribute any input to any or all outputs
Extends HDMI signals up to 328 feet (100 meters) using a single Cat6 cable
Extends 100Base-TX network connectivity along with the HDMI video
Can be daisy chained up to six units deep
Built-in bidirectional IR repeater
Supports High Speed HDMI functions including 3D video
Tech Choice strongly recommends using 22AWG 24AWG or active HDMI cables with Redmere technology to achieve the best results and to ensure minimum signal loss over longer distances.
The full 10.2Gbps bandwidth support means that this matrix supports all High Speed HDMI functions including all HDMI 3D video modes the extended 4K cinema resolution 32-bit Deep Color and high-definition compressed lossless audio such as DTS-HD Master Audio™ and Dolby TrueHD™. The matrix features a built-in bidirectional infrared (IR) signal extender which allows you to remotely control devices at the source or destination end of the connection. Additionally an IR Adapter allows you to use the IR repeater function with the HDMI cable connection.
The HDBaseT extender is capable of transmitting a full-duplex 100Mbps local area network connection alongside the HDMI and IR signals. The matrix has two RJ45 LAN jacks on the back panel while the HDBaseT Receiver has another two RJ45 LAN jacks. As long as one of the four jacks is connected to the network the other three will propagate the network connection. This allows you to wire another room for HDMI video IR remote control repeating and full internet access using only a single Cat6 cable!
Note: While the extender will function using unshielded Cat5e cabling we recommend the use of shielded Cat6 cabling for greater reliability over longer distances. Also note that any cable run through the walls must be rated for in-wall installations.
Here are available downloads related to this product:
Contemporary Research 232-ATSC Plus1 HDTV Tuner (232-ATSC Plus4)
The 232-ATSC+1 HDTV Tuner is an integrator-friendly HDTV tuner, controllable
with 2-way RS-232, IP, and IR commands. An onboard Web page enables remote Web control. A new menu-driven display simplfies setup, and a front-panel USB port makes firmware updates ...
MAXRAD 1575.42 MHz 3 dBic 5 volt high performance active
/ filtered GPS antenna. USB Comm Interface. Design allows for Magnet or Screw Mount.. Specs. GSA. Contract:. Schedule:. GS-35F-0548P. 70 - Information Technology. Frequency. 1575.42 MHz. Mobile Antenna Mounting ...
PRV450 All-Environment Multimedia Stereo Receiver. NMEA 2000 protocol allows compatibility
of the INFPRV450 with certain approved Multi Function Displays. Bluetooth Audio Streaming with id tagging, SiriusXM-Ready (subscription sold separately), 3.5" TFT color screen, AM/FM, 50W x 4, USB input, ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).