Televes DATBOSS Mix UHF VHF Amplified Outdoor HDTV Antenna LTE Filter (149483)

• Smart amplifier adjusts to overcome difficult reception areas where UHF and high-VHF signal is too weak or too strong
• Triple-beam construction uses the power of three yagi antennas in one design for strong 60 mile reception
• Low-"noise" 32dB amplifier provides more signal with less interference
• Manufactured in Europe to the most stringent quality controls
• Works in both active amplified mode, or passive mode, where power supply is by-passed
• Mounts to most standard masts. Click for recommended mast

• Smart Design - Added high-VHF elements to the classic UHF Yagi provides full HD coverage in a compact form. The triple-boom design adds strength extra signal gain and directivity while reducing signal echo. Enhanced double-U diple provides excellent frequency response for optimum signal flatness.
  
  
• Cuts down the noise - Shieled protects the signal switch and BOSS system from signal noise and is grounded for full protection against electrical issues. The smart amp also cuts down noise from reflections and other signal hinderences
  
  
• Top Quality - Built from European manufactured stainless aluminum for long life of HD reception
  
  
• Smart amplifier - Adjustable amp changes signal level for best signal. It's great for critical areas where signal can be too weak or too strong
  
  

Technical Specifications

 
• Manufactured in Europe
 
• Receives high-VHF and UHF
 
• Amplifies to 32 dB of gain
 
• Rated at 60+ miles
 
• LTE filter
 
• Works with or without power supply
 
• Mounts to 1.25"-2" masts
 
• Dimensions: 29"H x 33.875"W x 48.875"L

Mounting Options for Televes Antennas

Televes antennas will mount on any vertical mast or post with an outer diameter of 1.25" - 1.75". Here are some suggested mounting options.

	J-Mounts are recommended for installation on eaves or fascia boards. When mounting using a J-mount, make sure there is 3' open space behind the mount for the antenna. We recommend this universal J-Mount.
	Tripod mounts are recommended for temporary installations and should be secured with bolts or sandbags. We recommend this 5-foot mast and tripod mount kit.
	Non-penetrating mounts are designed for installations on level, flat surfaces and are secured by cinder blocks. We recommend this non-penetrating mount and mast kit (cinder blocks not included.)
	CommDeck mounts are designed for permanent roof installation and install without drilling holes in the roof. It is best installed when re-roofing. We recommend this CommDeck mount.
	Chimney mounts attach to your chimney without damaging the bricks and can be used for permanent installation. We recommend this chimney mount. (Mast not included: we recommend this mast)