Allows you to split the signal from an amplifier to up to 4 internal antennas with negligible signal loss
Includes a Two-year Manufacturer Warranty from Date of Purchase
The Wilson 859957 signal splitter allows you
to split the signal from an amplifier to up to 4 internal antennas with
negligible signal loss. The splitter covers 700-2300MHz, and so will work with
all the amplifiers on our site, as well as any future Wilson repeaters that
might be built for new technologies.
This 2-way splitter
allows you to drive two interior antennas from a single amplifier/repeater.
Because you are splitting equally the signal each antenna will receive is 1/2
of the original signal. This equates to about 70% of the coverage distance when
compared to driving a single antenna. You should use this splitter if the areas
you wish to cover are approximately equal in area.
splitter has N Female connectors. Typically a 2ft cable is used to connect the
splitter to the amplifier. Any cable length can be used, but the total cable
length in the system should be kept to a minimum to minimize attenuation. Lengths
of coaxial cable can then connect the splitter to the internal antennas.
Technical Specifications: - Frequency
800MHz, 1900MHz, Dual Band, iDEN, 2100MHz - Impedance 50 ohm -
Connector Type N Female - Signal Split Ratio Equal - Loss
Both ports -3dB
For use in signal distribution systems to split the amplified
signal with minimum signal loss. Equal amounts of signal sent to two antennas for similarly sized areas. Weatherproof case for indoor or outdoor use.. WARNING:. Cancer and Reproductive Harm ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).