Availability: Usually Ships Same Day Condition:New
Your Price: $6299
List Price: $99.99
The Wilson 859994 is a Three-way Splitter that allows you to split the amplified signal with minimum signal loss to three inside antennas in similarly sized areas.The Wilson 859994 has frequency of 700-2500 MHz. Comes with F-Female Connectors.
For splitting the amplified signal with minimum signal loss to three inside antennas in similarly sized areas.
Wilson 859994 75 Ohm Three-way Splitter
One input - three equal outputs
Frequency 700-2500 MHz
Impedance 75 ohms
Includes a Two-year Manufacturer Warranty from Date of Purchase
The Wilson 859994 signal splitter allows you
to split the signal from an amplifier to up to 4 internal antennas with
negligible signal loss. The splitter covers 700-2300MHz, and so will work with
all the amplifiers on our site, as well as any future Wilson repeaters that
might be built for new technologies.
splitter allows you to drive three interior antennas from a single
amplifier/repeater. Because you are splitting equally the signal each antenna
will receive is 1/2 of the original signal. This equates to about 70% of the
coverage distance when compared to driving a single antenna. You should use
this splitter if the areas you wish to cover are approximately equal in
Connections: The splitter
has N Female connectors. Typically a 2ft cable is used to connect the splitter
to the amplifier. Any cable length can be used, but the total cable length in
the system should be kept to a minimum to minimize attenuation. Lengths of
coaxial cable can then connect the splitter to the internal antennas.
Technical Specifications: - Frequency
800MHz, 1900MHz, Dual Band, iDEN, 2100MHz - Impedance 50 ohm -
Connector Type N Female - Signal Split Ratio Equal
Negative and positive traps are the most commonly used method
for pay television security. Negative traps block the video signal from entering the subscriber’s home. Positive traps decode a scrambled channel.. Features. Upper Frequency Response:. 50mHz). Impedance: 75 Ohms. ...
The OBM100 is an out of band data modulator for
use with the SCT2X4 headend satellite to cable transcoder. The purpose of the OBM100 is to provide a one-way data channel from the headend to a universe of set ...
The SPTERM from Skywalker are accessories to professionally complete your
system. Use these 75-Ohm Terminators on all signal outputs that are not connected to a television or VCR.. Features. Un-terminated outputs can cause a herringbone pattern to appear on ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).