Availability: Usually Ships Same Day Condition:New
Your Price: $5999
List Price: $79.99
Description
You have installed your TV antenna on your roof and have run your coax cable from the antenna to your TV. So why are you only picking up a few local channels? It’s probably that long cable run. This reduces your ability to receive a strong signal from your antenna to your TV. A TV antenna pre-amp might be what you need. This device will produce the juice your antenna needs to deliver more local TV channels.
This Antennas Direct pre-amp is an ultra-low noise, VHF/UHF mast-mounted device. It provides a gain of 15db, and features a 1.8 dB maximum noise figure to improve your TV antenna’s power. Antenna Direct is a top-selling manufacturer of TV antennas and pre-amps, and Solid Signal proudly carries the company’s products. Do you think a pre-amp would be a benefit to your TV antenna installation? We’d be happy to answer your questions and make a product recommendation. Just call us at 877.312.4547.
Key Features
Improves TV antenna signal in installations with loss due to long cable runs and splitters
Gain of 15db VHF/UHF and a 1.8 dB maximum noise figure
All-weather design for durability and long life
Frequency range 40-862 MHz
Features
Gain of 15db VHF/UHF and a 1.8 dB maximum noise figure
The PA-18 is a powerful low noise signal amplifier. It will perform best when connected properly. Remember an amplifier cannot create a signal. It will help over come the loss caused from cable runs and splitters.
The PA 18 comes with:
Low noise pre amplifier
Low loss power inserter
12V DV power supply
2 foot coax cable
4 foot coax cable
A pre amp will work best when it is amplifying the signal at its strongest point; nearest the antenna.
1. Connect the antennas transformer to the pre amp "In" port as shown using the supplied 2 foot cable.
2. Strap the pre amp to the antenna mast using the supplied cable tie.
3. Run your coaxial cable down lead (not supplied) inside your building and connect to the right port of the power inserter. (Do not reverse the connection!!)
4. Connect the left port of the power inserter to your digital receiver using the supplied 4 foot cable (above). (Do not reverse the connection!)
5. Plug the inserter to an 110v power source.
Downloads
Here are available downloads related to this product:
Product Reviews for Antennas Direct VHF-UHF TV Antenna Pre-Amp Ultra Low Noise (PA-18)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!
Average Review (2 reviews):
Five Stars:
2 (100%)
Four Stars:
0 (0%)
Three Stars:
0 (0%)
Two Stars:
0 (0%)
One Star:
0 (0%)
Recent Review: poncho167 - Fox Lake, IL - 5/29/2014 Worked great
Customer Reviews:
Filter:
Worked great poncho167 - Fox Lake, IL - 5/29/2014 6:15:12 PM The PA-18 antenna amplifier really brought my signal to life. I installed a whole house antenna system and it tested fine going to one TV only missing one channel. When I hooked up the other TV';s using a splitter, now some channels were struggling or not appearing at all especially when there was over-cast weather. Now I can see all the channels without any issues but an occasional flicker on a hard to reach channel, but it seems to correct itself on that.
Well worth the money in my situation. I also received great customer support!
performs as expected j - CT, CT - 9/11/2012 delivers performance as advertised. took very poor stations and brought them to a watchable level. this preamp is being used with an xg91 antenna(which also performs admirably). the big plus(and reason i chose the amp) is that it is powered by 12volts dc and by eliminating the 12volt transformer and feeding 12volts directly to the unit i am able to use it in my camp trailer that is without any 1
Blonder Tongue Broadband Indoor Distribution Amp Power Doubling
Description:
The BIDA 5900 Series Distribution Amplifier with an active return
path is a self-contained amplifier designed for CATV and SMATV signal distribution systems that use a cable drop as a signal source. This model comes with power-doubling technology and ...
Blonder Tongue Outdoor Distribution Amp 30dB 54-860 MHz
Description:
Designed with a cast-aluminum housing, the BODA is ideal for
outdoor pedestal as well as indoor back board installations. The housing utilizes a carbonized rubber and wire mesh gasket to provide excellent protection against RFI and moisture ingress. 5/8 ...
Description:
Amplifies and extends DirecTV AU9S Ka/Ku signals to high levels
for multiple distribution locations. Multiple powering options are included with these amplifiers. They may be coax line powered from either the RF input or RF output. An external transformer ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).
NEED TV ANTENNA HELP?
Share
