Availability: Usually Ships Same Day Limited Stock. Order Now! Condition:New
Your Price: $4499
List Price: $59.99
An antenna amplifier can help strengthen your TV signal. This signal booster makes up for signal loss from long cable runs and splitters. Increase antenna signal strength easily and affordably. Get better HDTV signal reception than you would with a non-amplified splitter. This product utilizes a 54-1002 MHz operating frequency.
Product Reviews for Channel Master 8-Port HDTV Signal Distribution Amplifier (CM-3418)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!
Average Review (11 reviews):
Recent Review: ComputerGeek - Kernersville, NC - 11/27/2015 The second one I've used (sold my previous house and left it with the buyer). Works very well!
The second one I've used (sold my previous house and left it with the buyer). Works very well! ComputerGeek - Kernersville, NC - 11/27/2015 8:57:39 PM Works great as a distribution splitter/amplifier. I used an attic mounted Clearstream 2V (directional UHF - all the channels in the area broadcast in the UHF range) and an antenna pre-amp to the CM3418 (unpowered) and it wasn't performing well. I switched to using the CM3418 for both the distribution and the amplifier and removed the pre-amp after discovering I was getting good signal with the antenna directly connected to a single TV. Upped the number of channels I received from 24 (marginally on a few) to 30 (I also shortened my runs going out from the CM3418 by centrally locating the unit to the TVs). Signal/Noise Ratio is now excellent on almost all channels. The only one not very good is off center but still receiving it from 22 miles away and it is at a 90 degree from the main N/S direction where most of the channels originate. I bought another CM3418 years ago in the Des Moines area and had good success with it as well.
HIGH QUALITY CONSTRUCTION Larry - Mesa, - 3/28/2013 This is a very robustly constructed product. It has very low self noise and seems to be a first rate product.Great for splitting the output from an antenna up to eight ways plus add some gain without degrading the signal.
The Distribution Amp works great! Walt - Rancho Palos Ve, Rancho Palos Ve - 3/28/2013 This distribution amp is used near a patch panel to send a source cable signal to several rooms at once with perfect performance at each location.
It Works! AJTISH - Central Illinoi, Central Illinoi - 3/28/2013 I use this distribution amplifier to distribute DTV signals from my rooftop DB8 antenna and CM7778 pre-amp. Signal is delivered flawlessly to multiple TVs and PCs with tuner cards.
Used to distribute OTA HDTV t Sonny - South La., South La. - 3/28/2013 Need something to distribute OTA signals and this works great for us.
Still works great Jim - Kansas, Kansas - 2/12/2012 Been two years now still works great
Great Product Bobz - Myrtle Beach, rtle Beach S - 2/4/2012 Using this amplifier along with DB=8 antenna for OTA HD reception installed now for about one year.This amp distributes to every room in the house pre-wired for cable and does a great job. I am very pleased. Only down side for some users is requirement for access to 110v AC outlet for power near the amp. Next will be a rotor to turn the antenna for more channels.
so far so good Todd the no mor - Berks County PA, Berks County PA - 3/28/2013 so far so good once I had to unplug because signal was breaking up since then working ok. I am using it with 2 antenna setup and combiner which is tough to keep a good signal to begin with. (2 UHF VHF Antennas facing different locations) terminators for unused outputs were not included
Almost perfect jelmore - Tulsa, - 3/28/2013 An excellent job of passing through video signals. Nice to be able to feed 8 HD signals. Had a little trouble with return path voltage so had to do an upstream split for the cable modem and bypass the splitter.
This a great Amplifies Does the job Ed - Palm Beach Gard, Palm Beach Gard - 3/28/2013 Used to distribute cable signal to eight tvs in a 5000 sq ft hall
Worked fine within warranty period WAG - Burlington, ington WI - 2/9/2012 Installed CM-3418 with all new OTA Channel-Master equipment worked fine for 13 months then by-pass light came on. No continuity from any of the 8 supply inputs/output ports. Called CM no longer covered by warranty need to replace failed distribution amp! I suggest looking at a different product
Kramer 1x5 Composite Video Distribution Amplifier (105VB)
The 105V is a high-performance distribution amplifier for composite video
signals. It takes one input, provides correct buffering and isolation and distributes the signal to five identical outputs.. Key Features. Bandwidth - 400MHz (-3dB). Connectors - RCA (105VB has ...
Blonder Tongue Outdoor Distribution Amplifier 30dB 54-1000MHz
Designed with a cast-aluminum housing, the BODA is ideal for
outdoor pedestal as well as indoor back board installations.The housing utilizes a carbonized rubber and wire mesh gasket to provide excellent protection against RFI and moisture ingress. 5/8 inch ...
Pico Digital Broadband Bi-directional Push-Pull Distribution
The Pico PIDA-1000 amplifier is a two-way broadband distribution amplifier
incorporating dual push-pull circuitry for extremely low distortion and high output levels. A selection of removable attenuator pads and equalizers are also available for the PIDA series.. Features. 54~1000MHz ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).