Availability: Usually Ships Same Day Condition:New
Your Price: $5454
List Price: $99.99
These CommScope 3.5” antenna mounting clamps are used to couple an antenna to another fixed pole or tower leg. These clamps are designed to work with antennas that have round tower legs with 1.25”-3.5” (35-89mm) outer diameter, and angled tower legs that measure up to 3” on a side. The center section of each clamp is welded and all parts are hot-dipped galvanized steel. Solid Signal offers the solution you need with this two pack of antenna mounting clamp kits from CommScope.
Used to mount aluminum base station antennas to round or angled tower legs
Comes with: two pipe-to-pipe crossover clamps and mounting hardware
Supports masts from 1.25”-3.5” OD
Galvanized for added corrosion protection
Center section welded for mechanical stability
Requires clean ground to tower leg or support pipe at attachment point
Andrew/Decibel Antenna Pipe to Pipe and Crossover Clamps.
For round tower legs 1" to 3-1/2" diameter or 3" x 3" angle legs. Set of 2 Clamps.
Here are available downloads related to this product:
Copper grounding kit with 5/8 copper rod, Copper wire and
connecting hardware. It includes four foot threaded copper ground rod, 5/8 ground rod clamp, u-bolt and saddle clamp, six feet #6 AWG bare copper wire & end caps.
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).