Includes a DISH Pro Plus Twin LNBF and a DISH Pro Dual (or DP Single) LNBF:
Valid receiver combinations include:
Any DISH Pro or DISH Pro Plus receiver.
Up to two DISH Pro Plus receivers each with DISH Pro Plus Separators for the single-cable installation advantage.
One Legacy receiver with one DISH Pro or DISH Pro Plus receiver.
Receivers NOT supported:
1 Legacy receiver alone
2 Legacy receivers
The following Legacy receivers will not have 129° software support: Models 1000, 2000, 3000, 4000, 5000, JVC-DVHS and DishPlayer 7100/7200.
Standard Configuration Installation Considerations
Standard cable limitations apply from LNBFs to receiver:
Receivers that support 129° will require a software download, and fall into one of the following categories:
129° is displayed in the Point Dish Satellite list.
129° shows up in the Point Dish Satellite list only after 119° is peaked, and a check switch is run (“generic satellite support”).
The standard configuration LNBFs can be removed and replaced with other LNBFs and/or used with switches for additional receivers or an additional orbital location.
Add a DP Plus 44 Switch: the DP Plus Twin/DP Dual (or DP Single) LNBF configuration can support additional receivers or an additional orbital location when connected to a DP Plus 44 switch. Both DP Plus Twin output ports and one DP LNBF output port are connected to the DP Plus 44 switch. The DP Plus
Twin’s LNB IN port is not operational when the LNBF is connected to the switch.
Replace with DISH Pro LNBFs:
Use a DP Twin (or DP Quad) and the DP Dual LNBF with a DP Plus 44 switch or DP34 switch for additional receiver support.
Use three DP Dual LNBFs with either a DP34 switch or a DP Plus 44 switch as needed.
REMEMBER: The DP Plus Twin and DP34 switch cannot be used in the same installation.
The following International Programming options from Dish Network will be available using the DISH 1000 satellite dish antenna:
* South Asian – Kannada
* South Asian – Bangla
* South Asian – Malayalam
* South Asian – Telugu