Availability: Usually Ships Same Day Condition:New
Your Price: $14517
List Price: $161.99
Unidapt cable tester is powered by a 9 volt battery. The cable status will be displayed on the LED panel to the right jack of one tester. Attach the local cable end to the left jack disconnect the cable from all equipment and attach the remote cable end installed cables can easily be tested by using two coaxial cable testers. The cable condition will be indicated on the front LED panel. To test free cables, attach each end of the cable assembly to the tester.
The 3M Dyntel Ultra Advanced Cable and Pipe Locator incorporates
advanced electronics to quickly and efficiently trace the path of underground cables and pipes. It provides accurate cable and pipe depth measurements, giving a digital readout in inches, feet ...
KD Tools Short Circuit Detector. Locates short circuits in 6v
& 12v systems right through upholstery, body panels and metal doorposts. Connect tester across burned out fuse. Move meter along wire routing. Meter needle will oscillate until short is ...
Bird Technologies RF Sampler Element Non-Directional Coupler
Bird RF sampler element, non-directional element coupler. Delivers un-rectified signal
at about -50dB from 25 to 1000 MHz, and accepts 500 watts of power. For RF signal observation, spectrum analysis, or frequency measurement. Special Order. Non-Cancellable and Non-Returnable
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).