Solid Signal > Wire and Cable > HDMI Accessories > Hall Research UHBX-WPC-P2
Hall Research Extender Transmitter-Receiver Wall Plate Kit (UHBX-WPC-P2)
Brand: Hall Research
No Reviews Available
Be the first to write one!
Availability: Usually Ships Same Day
Your Price: $760
List Price: $800.00
The extender kit is a combination of UHBX-SC-WP + UHBX-R-PSE from Hall Research that utilizes HDBaseT™ technology. It can send HDMI, IR, bi-directional RS-232, and PoH (Power-over-HDBaseT™) to 500 ft (150 m) on a single Cat6 cable. The extender uses only one +5v power supply, internally creates 48v PoH and complies with IEEE 802.3af handshake.
The P2 extender's receiver unit provides power to the sender. In standard mode, the UHBX-WPC-P2 supports DVI and HDMI signals of virtually any resolution up to 4Kx2K to 330 ft (100m), and in Long Reach mode it supports resolutions to 1920x1080 to 500 feet (150m). The devices are housed in compact and sturdy metal enclosures and have convenient mounting provisions. They are designed and manufactured in the USA.
Full-duplex RS-232 Serial Port extension is provided that can operate at any baud rate to 115,200 (independent of video activity).
The extender can also extend IR from one end to the other. IR Detector and IR Emitter cables are sold separately. The IR extension preserves the modulation(carrier) frequency and provides compatibility to virtually any standard. It supports modulation range from 30 KHz to 60 KH. Two user selectable distance modes are available: Standard(default) and Long Reach. If the length of UTP cable is less than 100 meters (330 ft), then STD mode should be used. For the lengths above 330 feet Long Reach (L.R.) mode must be set. Long Reach setting can extend a maximum of 1080p@60 Hz, 8-bit color (does not support deep-color or 4Kx2K), RS232, IR, and Power up to 500ft (150m).
- Extends HDMI or DVI video to 500 ft on just one Cat6
- Includes RS232 and IR extension in both directions
- Supports virtually all HDMI and DVI resolutions including 4Kx2K
- Only one end requires power, the other side is powered via UTP
- Power-over-HDBaseT™ meets IEEE 802.3af standard
- Sturdy metal enclosures with mounting provisions
- Complies fully with HDBaseTT standard
- Runs from just one +5vDC supply
- RS232 Supports all baud rates regardless of presence of video
- IR extension is carrier frequency agnostic and supports 30 KHz to 60 KHz modulation to provide compatibility across all IR standards
- Fully isolates ground between TX and RX sides
- Compact, Rugged, Reliable, and Economical
You May Also Consider
Product Reviews for Hall Research Extender Transmitter-Receiver Wall Plate Kit (UHBX-WPC-P2)
Product reviews help other customers decide which product to purchase, where the best deals are, and your get a sense of
what to expect with the product. Write a Review!