Availability: Usually Ships Same Day Condition:New
Your Price: $19670
List Price: $229.99
The Elkor WattsOn-DISP allows for the local display of electrical measurements performed by the WattsOn Power Transducer. Its small size and form factor allow for an easy and clean installation through a panel with the included mounting hardware. Optionally, an NEMA 4X bezel may be provided to allow for installation in harsh environments. The display parameters are selected by configuring the main WattsOn unit using RS-485 (Modbus). It may be used with WattsOn-1100 units (firmware 4.3 or higher).
The Wattson transducer configured for use with the display uses the second pulse output is used for data transmission from the WattsOn. This leaves the RS-485 port free for communication with any other RTU. The display features a LED backlight allowing viewing in any condition.
Special Order Product. Non-Cancellable and Non-Returnable.
APC 9-Outlet G-Type 15-Amp Rack-Mountable Power Conditioner
APC® 9-outlet G-type power conditioner with a maximum input current
of 15A facilitates AV power protection from electrical noise interference and damaging power transients. Power filter with 120V input voltage comes with rack mounting brackets.. Features. .9 outlets-8 on ...
SoundQuest- SQCAP2M 2-Farad Power Capacitor with Digital Display
Keep your music at the optimal performance level every time
with the SoundQuest line of capacitors with ultra low ESR. The high-current output, high ripple-current capabilities, reverse-polarity warning, and large 20-volt surge capabilities, which will keep your music clear ...
Solid Signal is an authorized retailer of DISH
Network L.L.C. DISH, DISH Network and DISH Network logos are trademarks, registered trademarks and/or service marks
of DISH Network L.L.C. and/or its affiliate(s). The DISH Network trademarks, registered trademarks and/or service
marks are used under license of DISH Network L.L.C. and/or its affiliate(s).