Easy Up Non-Penetrating Roof Mount with 53in Mast (EZ-NP-60-200)

Easy Up EZ-NP-60-200 Non-Penetrating Roof Mount

Install a satellite dish, antenna, wireless equipment, weather station, or similar rooftop equipment on a flat surface without drilling through the roof. The Easy Up EZ-NP-60-200 uses ballast for stability and includes a 53-inch mast, mounting tray, support hardware, and installation hardware.

Why Choose the EZ-NP-60-200?

This non-penetrating roof mount is a practical choice when you need a stable rooftop mounting point while preserving the roof membrane. The low-profile tray works on flat roofs and other flat surfaces where a permanent roof penetration is not desired.

Key Features

• Non-penetrating design for flat roofs and other flat surfaces
• 53-inch mast with 2-inch outside diameter
• 18-gauge galvanized steel mast for durable outdoor use
• 35 x 28-inch standard tray footprint
• Tray accepts up to six standard 8 x 8 x 16-inch concrete blocks for ballast (blocks not included)
• Includes mast, tray, support components, and installation hardware
• Suitable for satellite dishes, antennas, wireless internet equipment, weather stations, and similar equipment
• Made in the USA

Specifications

• Model: EZ-NP-60-200
• Manufacturer: Easy Up
• Mast: 53 inches long x 2 inches OD
• Mast construction: 18-gauge galvanized steel
• Tray footprint: 35 x 28 inches
• Ballast: Accepts six standard concrete blocks; blocks not included

Installation Notes

The mount ships unassembled. Place it on a suitable flat surface, assemble it with the included hardware, and add ballast based on the attached equipment, local wind conditions, roof structure, and applicable building requirements. Professional installation is recommended. This is a non-engineered mount, so a qualified installer should determine whether the application and ballast are appropriate.